Grundig Vision 4 26-4931 T, Руководство пользователя

Страница: 26 / 34

27­
ENGLISH
SPECIAL­SETTINGS
­-----------------------------------------------------------------------------------------------------
Tuning­digital­television­stations
This search deletes all television stations in-
cluded in the channel list!
Tuning­all­digital­television­stations­
with­cable­connection­by­auto­tun-
ing
1 Open the menu with » İ «.
– The »PICTURE« menu appears.
2 Select the »CHANNEL SETUP« menu with
»
–
« or »
+
«.
3 Select »Auto Tuning« with »
V
« or »
Λ
« and
confirm with »
●
«.
4
Select »Country Selection« by pressing »
V
«
or »
Λ
« and press »
–
« or »
+
« to make the
setting.
5
Select the »Scan Type« with »
V
« and press
»
–
« or »
+
« to select the »DTV«.
– The »Searching...« menu appears, and the
search for digital TV stations begins. This
may take several minutes depending on the
number of television stations received.
– The search is ended when the »Programme
Table« appears.
Note:
7
You can stop the search by pressing »
İ
«.
6 Press »
İ
« to end the setting.
Tuning­analogue­television­sta-
tions
This setting is only necessary if you cannot re-
ceive any digital stations and you have not car-
ried out an analogue search during initial setup.
The television station can be set directly or using
the search.
Switching­the­television­to­ana-
logue­channels
1 Open the »INPUT SOURCE« menu by press-
ing » AV «.
2 Select input source »ATV« with »
V
« or »
Λ
«
and press »
●
« to confirm.
Note:
7
Additional operations are explained in the
following sections.
Re-tuning­all­analogue­television­
channels
These settings are only necessary if you can not
receive any digital stations or if you want to re-
tune all analogue channels.
The analogue television stations are listed in the
channel list after the digital television stations.
Note:
7
Plug the rooftop antenna cable (for ana-
logue television stations) into the » ANT­IN «
socket on the television.
1
Open the menu with »
İ
«.
– The »PICTURE« menu appears.
2
Select the »CHANNEL SETUP« menu with
»
–
« or »
+
«.
3 Select »Autotuning« with »
V
« or »
Λ
« and
confirm with »
●
«.
4 Select »Country Selection« by pressing »
V
«
or »
Λ
« and press »
–
« or »
+
« to make the
setting.
5 Select the »Scan Type« with »
V
«.
Press »
–
« or »
+
« to select the »ATV« display
and start the search with »
●
«.
CHANNEL SETUP
Autotuning
Digital Manual Tuning
Analogue Manual Tuning
Programme Table
Signal Information
CA - Module
Removed
Select
Exit
Active Antenna Power On
s
s
s
s
Back
Z