14
ENGLISH
Important
7
Do not install the charging station anywhere where
it is exposed to direct sunlight or near a heater/
radiator.
Do not install the charger outdoors.
3
Choose a suitable drill bit for the screws and wall
plugs supplied.
4
Drill two holes approx 30 cm above the floor, push
in a wall plug and screw in the screws, then hang
up the charging station.
J
Charging
If run with the installed rechargeable nickel metal hyd
ride batteries, use the charging station with the mains
adapter as a charger.
1
Remove the accessory used.
2
Insert the appliance in the charging station
J
so
that it precisely fits.
– The charging contacts of the appliance and the
charging station touch each other.
3
Plug the mains adapter into the wall socket.
– The charging process begins, the charging indi
cator
F
lights up red.
– The charging indicator remains lit until the appli
ance is removed from the charging station or the
mains adapter plug is disconnected.
Note
7
Fully charge the batteries before using for the first
time or if the batteries have not been used for a
long time (20 hours).
7
Charge the appliance at room temperature. Lower
or higher temperatures have a negative effect on
the life of the batteries.
7
The ambient temperature should be between 5˚C
and 40˚C.
7
When fully charged, the appliance works for
around 12 minutes. It is not advisable to charge
the batteries after every use, especially if you do
not use the appliance for the full 12 minutes. Only
charge the batteries when they are completely
discharged. This increases their life. Do not charge
it every day.
7
The device does not end the charging process
automatically. Therefore, remove the device from
the charging unit after 16 hours or disconnect the
power supply unit from the socket. In this way, you
save electricity.
Switching on and off
1
Remove the appliance from the charging station
J
.
2
Depending on the requirements, insert one of the
accessories into the appliance‘s vacuum intake
I
.
3
Switch on the appliance by pushing forward switch
D
.
4
Switch off the appliance by pushing back switch
D
.
5
Remove the accessory used.
Empty dust container and clean
1
Hold the appliance vertically with the vacuum
intake
I
facing downward.
2
Press pushbutton
C
and remove the dust container
from underneath.
3
Remove the holder and filter
B
from the dust con
tainer.
Note
7
You can wash the filter from time to time with hot
soapy water.
After washing, allow the filter to completely dry.
4
Empty the dust container
A
, wash out and dry.
Note
7
Allow the dust container to completely dry before
you replace it in the appliance.
5
Hold the appliance vertically facing upwards.
6
Press button
C
.
OPERATION
__________________________________________________________
