Grundig UMS 2010, Руководство пользователя, Страница: 10 / 23

ENGLISH
10­
SETTINGS
­---------------------------------------------------------------------------------------------------------------------------------------
Setting­the­clock
The first time you connect the hi-fi system to the
mains, it switches to standby.
Display: »
- - : - -
« instead the time.
1 In standby mode, press and hold » DISPLAY «
on the remote control for 2 seconds.
– Display: » 24 H «.
2
Select the hour format (12 or 24 hours) with
»
3
« or »
4
« on the hi-fi system or »
5
«
or »
6
« on the remote control and confirm with
» DISPLAY «.
– Display: the hours flash.
3 Select the hours with »
3
« or »
4
« on the
hi-fi system or with »
5
« or »
6
« on the remote
control and confirm with »
DISPLAY
«.
– Display: the minutes flash.
4 Select the minutes with »
3
« or »
4
« on
the hi-fi system or with »
5
« or »
6
« on the
remote control and confirm with »
DISPLAY
«.
– Display: the current time.
Notes:
7
The current time is displayed in standby
mode – with reduced brightness.
7
The time must be reset after a power failure
or after disconnecting from the mains.
Tuning­and­storing­radio­stations
You can store up to 40 stations in the FM and in
the AM frequency range on preset presets.
Programming­radio­stations­–­
automaticaly
After starting the automatic station search func-
tion, the device searches for radio stations with
the best reception – first for FM, then for AM.
The statioms will be stored automatically.
Automatic programming will start with a cho-
sen preset number. From this preset number up-
wards, former programmed radio stations will
be overridden. The system will only programme
stations which are not in the memory already.
1 Switch on the hi-fi system from standby mode
by pressing » 8 « or » SOURCE «.
2
Select the input source TUNER with
» SOURCE « on the hi-fi system or with » TUN-
ER « on the remote control.
3
Press »
+­PRESET­-­
« on the hi-fi system or »
V
«
or » Λ « on the remote control to select the pre-
set number where programming should start.
Note:
7
If no preset number is selected, default is
preset (1) and all your presets will be over-
ridden.
4 Press » PROG « for more than 2 seconds to
activate programming.
– Display: » A uto « and »PROG« flashes, avail-
able stations starts to be programmed in or-
der of waveband reception strength.
Notes:
7
The automatic station search is finished, if in the
display »
A uto
« and »PROG« disappears, you
will hear the station stored at preset position 1.
7
To stop the automatic programming, press
either tuning » PROG « and »
7
/ « but-
ton to the same time.