Assembly:
- Disconnect the mains plug
- Loosen the rear of the cabinet and pull it backwards, unplug the connector of the subwoofer from the Click Fit board (option),
remove the rear of the cabinet
- Undo the screws on the left/right of the chassis and pull the chassis to the back
- Loosen the securing bracket
- Remove the cover:
Detach catch
A
at the side from the chassis frame (Fig.1), disengage catches
B
and hinge away the cover
- Press the 2 catches of the AF Module on the bottom of the chassis together and remove the AF Module
- Pull off the earth ring from the tuner input of the IF Module
- Press the 2 catches of the IF Module on the bottom of the chassis together and remove the IF Module
- Attach the pieces of adhesive tape included in the delivery to the tuner and the electrolytic capacitor of the SAT Module
(diagram)
- Plug the SAT Module into the multipoint connector between the AF and IF Amplifier, an earlier fitted Signal Module with
Splitter must be removed
- Unplug the connector ST-AUX 1 from the AF Module and insert it into the SAT Module ST-AUX 1A (red, applicable only
to TV sets with VGA interface)
- Connect the 3-core cable enclosed with the delivery to the SAT Module (ST-AUX 1B) and the AF Module (ST-AUX 1)
(applicable only to TV sets with VGA interface)
- Connect the 6-core cable enclosed with the delivery to the SAT Module (ST-I2 S1) and the AF Module (ST-I2 S1)
- Refit the IF Module or insert the second SAT Module instead of the IF Module, attach the earth ring to the tuner input (the
two cables enclosed are not needed)
- Insert the AF Module
- Lock in the securing bracket (take care of the cable layout)
- Insert the SAT cover into the cutout of the cover (only applicable to TV sets with Signal Module with Splitter)
- Break the prepunched cutout
C
for SAT input off the cover (Fig.1)
- Break the prepunched cutout
D
for the second SAT input off the cover of TV sets with two SAT Modules
- Attach the cover and lock it in
- Slide the chassis in and fasten it with the 2 screws (left/right)
- Plug the connector of the subwoofer into the Click Fit board (option) and refit the rear of the cabinet
- Close the TV set
Connect the mains plug and switch the TV set on
The TV set starts with ATS-Reset
Select the language / country. On confirmation of the country, the tuning system will start automatically.
ST-AUX1A
ST-AUX1B
ST-I2S1
A
B
C
B
Fig.1
SAT-Baustein / SAT Module SER 300
beigelegter Klebestreifen
adhesive tape included
D
