GB
Fitting Instructions
Built-in Satellite Receiver SER 251 Order No. G.AF 91000
for TV Chassis CUC 2032…2080
consisting of:
SAT Module
29504 106 2500
Processor Board with EPROM
29305 319 0300
Hexagon Headed Nut
81189 993 9400
Fitting Instructions
72010 029 1001
Operating Instructions
28017 942 0401
Note to the TV chassis CUC 2033 / 2058 / 2059 / 2080:
For units equipped with a processor board 29305 219 1400 and having a software version 29798 010 0100 or higher, the
replacement of the processor board and of the EPROM is
not necessary
.
Attention: Observe MOS regulations
Assembly:
- Disconnect the mains plug and open the TV set by removing its rear panel.
- Disengage catch
Y
.
- Disengage the locking lugs
Z
and remove the cover.
- Cut off the fixing lug
X
.
- Break the provided cutout for SAT aerial input.
- Disconnect R43050 on the chassis board.
- Replace the processor IC81050 by the Processor Board 29305 319 0300 (see note).
- Plug the SAT module on the connector ST-SB of the chassis.
- Attach the cover and lock it in.
- Screw hexagon headed nut on F-connector of SAT module.
- Attach the rear of the cabinet and connect the set.
- After switching the unit on the "Adjust language on screen" menu appears automatically. Via the menu –> "Adjust language
on screen" –> "Adjust country" –> "Satellite" –> select the desired satellite with the cursor button "
ǵ
" or "
Ƕ
" then confirm
with "OK". After selecting the satellite the automatic station search is started automatically. The programmes are allocated
in the order preprogrammed in the factory for the SAT module then are stored automatically.
Notes:
On application of a DiSEqC multi-switch it is to be checked whether Pin 15 of the SAT Module is connected with Pin 16 of
IC81050 on the chassis board.
If they are not, connect them.
Abdeckung
Cover
Z
Z
Y
X
