Grundig GWN48430CG, Руководство пользователя

Страница: 14 / 48

40 cm
100 cm
• To prevent flowing of dirty water
back into the machine and to
allow for easy discharge, do not
immerse the hose end into the
dirty water or do not drive it in the
drain more than 15 cm. If it is too
long, cut it short.
• The end of the hose should not
be bent, it should not be stepped
on and the hose must not be
pinched between the drain and
the machine.
• If the length of the hose is too
short, use it by adding an original
extension hose. Length of the
hose may not be longer than 3.2
m. To avoid water leak failures,
the connection between the
extension hose and the drain
hose of the product must be fitted
well with an appropriate clamp as
not to come off and leak.
Adjusting the feet
A
WARNING:
In order to ensure
that the product operates more
silently and vibration-free, it must
stand level and balanced on its feet.
Balance the machine by adjusting
the feet. Otherwise, the product
may move from its place and cause
crushing and vibration problems.
• Loosen the lock nuts on the feet
by hand.
• Adjust the feet until the product
stands level and balanced.
• Tighten all lock nuts again by
hand.
A
WARNING:
Do not use any tools
to loosen the lock nuts. Otherwise,
they will get damaged.
Electrical connection
Connect the product to a grounded
outlet protected by a 16 A fuse. Our
company shall not be liable for any
damages that will arise when the
product is used without grounding in
accordance with the local regulations.
• Connection must comply with
national regulations.
• The wiring for the electrical
outlet circuit must be sufficient
to meet the appliance
requirements. Use of a Groud
Fault Circuit Interrupter (GFCI) is
recommended.
• Power cable plug must be within
easy reach after installation.
• If the current value of the fuse
or breaker in the house is less
than 16 Amps, have a qualified
electrician install a 16 Amp fuse.
• The voltage specified in the
"Technical specifications" section
must be equal to your mains
voltage.
• Do not make connections via
extension cables or multi-plugs.
B
WARNING:
Damaged power
cables must be replaced by the
Authorized Service Agents.
14