ENGLISH
21
RECORDING
_______________________________________________________________________________
Programmed recording –
by entering the ShowView number
Notes:
The time and date must correctly be set on the recorder.
The ShowView numbers of the different broadcasts can be found in TV
programme guides.
If all programmed recording positions (TIMER positions) are occupied, you
must clear one position, refer to “Clearing programmed recording data” on
page 26.
Programming can be aborted at any time by pressing the »
88
« button.
SHOWVIEW® is a trademark of Gemstar Development Corporation.
SHOWVIEW is manufactured under licence from Gemstar Development
Corporation.
Preparation
Switch the TV set on.
Select the »AV« programme position for video playback on the TV set.
Insert a cassette with sufficient playing time and intact erase tab (cassette not
erase-protected) into the cassette compartment until it is fully pulled in.
If a cassette is already inserted, switch on with the »
■
« button.
If the recorder is in recording standby mode, de-activate this mode with the
»
TIMER ON/OFF
« button.
Example
1
Start programming with the »
TIMER SV
« button.
– The »SHOWVIEW« table appears on the picture screen.
2
Enter the ShowView number of the desired TV programme using the
»
0 … 9
« buttons.
Note:
If incorrect entries are made, the ShowView number can be cleared digit by
digit with the »
CLEAR
« button.
If the programme is to be recorded daily or weekly at the same time, use the
»
D
D
« button to select the » ONCE WEEKLY DAILY« line then select the
desired function with the »
F
F
« or »
E
E
« button.
The “daily” function cannot be used for recordings on Saturday or Sunday.
■
➔
SHOWVIEW NO.
–
ONCE
WEEKLY DAILY
w q
: SELECT
0~9 :DATA
OK :ENTER
INFO:EXIT
■
➔
SHOWVIEW NO.
12555
ONCE
WEEKLY DAILY
w q
: SELECT
0~9 :DATA
OK :ENTER
INFO:EXIT
