ENGLISH
22
OPERATION________________________________
Preparation
1
Remove all packaging material and stickers.
Dispose of them according to the applicable
statutory regulations.
2
Before using the appliance for the first time,
carefully clean all parts that come into contact
with milk. (See the “Cleaning and care” section.)
3
Unroll the power cord
H
from the power cord
storage area
I
. Pass the power cord through
the slot on the base.
Operation
1
Place the milk jug
C
on a clean, flat surface.
a. Assemble the milk frother as shown below.
b. Attach the frothing whisk
B
for frothing milk.
Hold the whisk by the black handle and lower
it into position. Then press the top of the whisk
to secure it into place. Do not hold the frothing
whisk by the springs.
OR
c. Attach the mixing paddle
F
for heating milk.
a
b
c
d
2
Pour the milk into the milk jug
C
. Make sure
you do not fill it above the maximum capacity
(as detailed in the table below) or below the
minimum mark. Look inside the milk jug to make
sure you do not go above the MAX mark
d
for
frothing or heating milk, otherwise the milk may
spill out of the milk jug.
3
Put the lid
A
on and push down to secure it
into place.
4
Place the milk jug
C
onto the base
E
making
sure the base is placed on a heatresistant, even,
stable, dry, nonslip surface.
5
Insert the plug
H
into an earthed wall socket.
The On/Off button
D
will light up blue.
6
Select the function you want from the table below
and press the On/Off button
D
the correct
number of times for your desired function.
Function
On/Offbutton
D
Max.milklevel
Heat & froth Press once – flashes red
300ml
Heat only
Press twice rapidly –
steady red
700ml
Froth only
Press three times rapidly –
flashes blue
300ml
Note
The appliance will switch off automatically once the
frothing / heating process is complete.
7
Press the On/Off button
D
at any time to stop the
process. The light will become blue (steady).
8
When the appliance stops, open the lid
A
. Use
a spoon to scoop out the froth before you pour
the milk.
9
Pull the plug
H
from the earthed wall socket.
Tips
To make measuring easy, there are max/min markers
on the milk jug.
When frothing milk, use cold semiskimmed or UHT
milk for best results. Full milk does not froth well
because it has a higher fat content.
The appliance heats milk to the perfect temperature
for coffee ensuring the flavour is not impaired and
it quickly reaches drinking temperature so you can
start sipping away sooner.
If you want slightly warmer milk, leave the milk in
the jug for a further 30 seconds after it has finished
heating or frothing.
After frothing or heating wait two minutes for the
thermostat to reset before using the appliance again.
The appliance is designed to heat and froth milk. If
you add coffee granules, hot chocolate powder or
other flavourings make sure you thoroughly clean
the milk jug immediately after use.
