Grundfos SRP Series, Инструкция по установке и эксплуатации

Страница: 16 / 21

Eng
lish (US)
16
9.3 Oil
9.3.1 Oil quality
Gear oil designation for SRP pumps according to DIN 51502:
ISO VG 68.
For unobstructed operation Shell Omala oil is recommended.
9.3.2 Oil quantity
9.4 Oil change
Place the pump in a horizontal position on supports and place a
pan underneath to collect the oil.
4. Remove screw (pos. 2). See fig. 20.
5. Loosen and remove oil drain screw (pos. 1), and allow the oil
to drain from the chamber into a glass. Leave the oil in the
glass for approx. 10 minutes and check if it contains water.
If the oil contains water, the shaft seal must be replaced.
6. Clean and refit the oil drain screw (pos. 1).
7. Fill oil into the oil chamber through the filling hole (pos. 2).
Quantity according to section 9.3.2 Oil quantity.
8. Refit screw (pos. 2).
Fig. 20 Position of oil drain and oil filling screws
Type
Gearbox
[oz (l)]
SRP.11.12.524.
40.5 (1.2)
SRP.15.12.628.
SRP.19.12.720.
SRP.26.12.805.
SRP.30.12.883.
SRP.40.12.513.
SRP.55.12.607.
SRP.75.12.722.
SRP.95.12.805.
SRP.48.20.254.
SRP.68.20.299.
SRP.95.20.363. 84.5 (2.5)
SRP.136.20.406. 84.5 (2.5)
SRP.95.32.260.
84.5 (2.5)
SRP.163.32.308.
SRP.204.32.334. 135.3 (4.0)
SRP.176.32.355. 84.5 (2.5)
SRP.272.32.374.
135.3 (4.0)
SRP.245.32.381.
SRP.326.32.418.
SRP.245.32.422.
Warning
When loosening the oil level screw, note that
pressure may have built up in the chamber.
Do not remove the screw until the pressure has
been fully relieved.
Note
Note
Used oil must be disposed of in accordance with
local regulations.
T
M
0
294
79
27
04
1 3
2