18
7.3 Setting to min. curve duty
Press
continuously to change to the min. curve of the pump
(bottom light field flashes).
To change back, press
continuously until the desired setpoint
is indicated.
Fig. 30
Min. curve duty
7.4 Start/stop of pump
Start the pump by continuously pressing
until the desired
setpoint is indicated.
Stop the pump by continuously pressing
until none of the light
fields are activated and the green indicator light flashes.
8. Setting by means of R100
The pump is designed for wireless communication with the
Grundfos remote control R100.
Fig. 31
R100 communicating with the pump via infra-red light
During communication, the R100 must be pointed at the control
panel. When the R100 communicates with the pump, the red
indicator light will flash rapidly. Keep pointing the R100 at the
control panel until the red LED diode stops flashing.
The R100 offers setting and status displays for the pump.
The displays are divided into four parallel menus, fig. 32:
0. GENERAL (see operating instructions for the R100)
1. OPERATION
2. STATUS
3. INSTALLATION
The figure above each individual display in fig. 32 refers to the
section in which the display is described.
TM
00 73
46 130
4
TM
02
09
36
05
01
H
Q
