En
gl
is
h (
G
B)
4
3.1 Mechanical installation
Before installation, check the oil level in the oil
chamber. See section
The DWK pumps are suitable for free-standing
installation with a hose or flange connection on top of
the motor.
3.1.1 Lifting the product
It is very important to use the approved lifting
equipment.
The weight of the specific product is stated on the
nameplate.
Always lift the product from the lifting eyes on top of
the motor.
DANGER
Electric shock
Death or serious personal injury
- Before installation and the first startup
of the product, check the power cable
for visible defects and measure the
cable resistance to avoid short circuits.
The pumps are designed for operation in
vertical position only.
WARNING
Crushing hazard
Death or serious personal injury
- All lifting equipment must be rated for
the purpose and checked for damage
before any attempts are made to lift the
product. The lifting equipment rating
must under no circumstances be
exceeded.
CAUTION
Crushing hazard
Minor or moderate personal injury
- The area below the lifted pump must be
clear of people and marked off.
- Lift the pump in a way that the pump will
not start swing.
- Place the pump on a solid foundation
which is suitable to hold the weight.
- Make sure that the pump cannot roll or
fall over.
CAUTION
Crushing hazard
Minor or moderate personal injury
- Always check the lifting bracket and
chain for corrosion or wear before
lifting.
- Always lift the product by its lifting
bracket or by means of a fork-lift truck.
- Never lift the product by the power
cable or the hose or the pipe.
CAUTION
Crushing hazard
Minor or moderate personal injury
- Make sure the lifting bracket is
tightened before attempting to lift the
product. Tighten if necessary.
Do not lift the DWK pumps from the
brackets on the motor.
TM0
7
0
30
9 4
8
1
7
Do not use for lifting