Grundfos Conex DIA-2, Инструкция по установке и эксплуатации

Страница: 31 / 612

English (GB)
31
11.5 Setup
All standard settings of the device can be defined in
the "setup" menu. During initial commissioning,
basicHfunctions are configured which after that
should only be altered rarely or even not at all.
The "setup" menu
can only be accessed by persons
having full rights.
See section
11.5.8 Code function .
Enter the code number.
11.5.1 Selection of measured values for chlorine, chlorine dioxide, ozone, peroxide and pH
Fig. 26 Selection of measured value in menus "parameter 1" and "parameter 2"
* pH-comp. chlorine is only available if chlorine and pH have been selected as parameters.
1. Select the line "parameter 1" / "parameter 2" using the [Up] and [Down] buttons, and press [OK] to switch to
the corresponding menu.
2. Use the [Up] and [Down] buttons to select the measured variable (parameter). Press [OK] to confirm.
3. Use the [Up] and [Down] buttons to select further settings. Press [OK] to confirm.
TM
03 67
33 45
06
setup
parameter 1
parameter 2
off
chlorine
chlorine dioxide
ozone
off
pH
temp. meas.
on
off
temp. comp.
on
off
temp. meas.
on
off
temp. meas.
on
off
pH-comp. chlorine *
on
off