Grundfos CIM 150 PROFIBUS DP, Функциональный профиль и руководство пользователя

Страница: 25 / 36

English (GB)
25
8. Product simulation
The CIM module can be put in product simulation mode in which
case it will generate life-like simulated values of all the
PROFIBUS/PROFINET input data modules.
It will thus be possible to connect a PROFIBUS/PROFINET
master to CIU 150 or CIU 500 without this device being
connected to a real pump in a real-life system. In an office
environment, it can then be verified that communication works
and data is being received and handled correctly by the
PROFIBUS/PROFINET master application program, for example
PLC program, before the equipment is installed under real-life
conditions.
8.1 CIM 150 product simulation
Product simulation mode is entered when the hexadecimal
address switch has one of the values shown in the table below:
The effective address will be 15 (0x0F).
Only input modules are simulated. The data read has dummy
values and no real product functionality is simulated.
8.2 CIM 500 Product Simulation
Product simulation mode is entered via the webserver. See
section
A.4 PROFINET IO configuration
on page 33 .
Address setting (section
5.4 Setting the PROFIBUS
address )
Simulated product
SW3 SW4
F 0 Pump profile
F 1 Booster system profile
F 2 CR Monitor profile
F 3
MP 204 motor protector
profile
F 4 Digital Dosing DDA profile
F 5 Wastewater system profile
Pumpland.ru