Support beam por6on
of the Sungazer frame
The Sungazer frame is profile specific and
is therefor to be ordered to suit the
shee6ng profile used.
Note
Cross sec6on through support beam por6on of standard Sungazer
1270 over Sungazer frame
Sungazer frame (support beam por6on)
Klip-Lok 700 shee6ng
Sliding brackets to be used on side sheets
when length exceeds 30m for steel sheets
& 20m for aluminium sheets. For shorter
sheets use S10 brackets.
S10 brackets to centre ribs. Please note that
if length exceeds 30m for steel sheets & 20m for
aluminium, then sliding brackets to be used.
Support beam por6on
of the Sungazer frame
Содержание Sungazer
