3
NOTES
You do not have to be concerned about
polarity, just make sure the plug is held in place
magnetically
Fig. 2
Plug the charging cable
into any USB port such
as computer, cell phone
charger, cube or even car.
The LED light on the base
of the screwdriver handle will glow RED when
the battery is being charged. The LED will glow
GREEN when the battery is fully charged
NOTES
1. If the LED does not glow when the USB plug is
inserted into the USB port, it means that USB
port is not "live"
2. The time to fully charge a depleted battery will
vary depending upon the output of the USB
device being used to charge the battery. This
can vary from 45 min to 5 hours or more
ASSEMBLY AND OPERATION
Removing a bit from the bit
storage cartridge
Rotate the cartridge knob (1)
until the desired bit is visible
in the cartridge window (2)
Fig. 3.
Pull outward on the cartridge
knob until the bits are fully
exposed (Fig. 4)
Remove the desired bit and
return the cartridge to its
original position within the
screwdriver
INSTALLING A SCREWDRIVER BIT
WARNING
Never hold the screwdriver with your fingers near
the switch while changing the screwdriver bits.
Accidentally touching the switch may start the
tool and possibly cause an injury.
Insert the screwdriver bit (1)
into the chuck (2) until the bit
is securely held in the chuck by
the magnetized chuck (Fig. 5)
FORWARD/REVERSE SWITCH
To drive screws, press the
upper portion of the trigger
switch (1) (Fig. 6)
To remove screws, press the
lower portion of the trigger
switch (2)
platform. Holding the work by hand or against
your body is unstable and may lead to loss of
control
• Always wear safety goggles or eye protection
when using this tool
• Always check to make sure the area where
screws are being driven or where holes are
being drilled does not have any hidden wiring.
Contact with a "live" wire will make exposed
metal parts of the tool “live” and could result in
an electric shock to the operator
• Do not drive screws or break into existing walls
or other blind areas where electrical wiring
may exist. If this situation is unavoidable,
remove all fuses or disconnect all breakers
feeding the work area
• Never hold the body of the screwdriver near
the switch while changing bits. Accidentally
touching the switch may start the tool and
possibly cause an injury
• Always use the correct shape of screwdriver
bit that matches the head of the screw
• Always use the largest size screwdriver bit that
will properly fit into the head of the screw
• Do not use worn or damaged screwdriver bits.
Worn or damaged screwdriver bits will not
drive the screw properly and may jump out of
the screw head, causing possible injury and
damage to the work-piece
BATTERY & CHARGER SAFETY
WARNING
• If the lithium-ion battery no longer charges
properly or is damaged, the battery must
not be discarded as household trash, burnt
or thrown into water. The battery must be
disposed of as hazardous waste in accordance
with all municipal requirements
• Do not incinerate a discarded battery. It can
explode in a fire
• Charge the battery only with the 4V USB
charging cable supplied for this 4V Li-ion
screwdriver
• For best results, charge the battery when the
temperature of the battery and the work area
is at or above 0° C (32° F) and below 45° C
(113° F)
CHARGING THE BATTERY
WARNING
Use only the specified 4V Li-ion charging cable
supplied with your tool. Using any other charging
system may damage the battery and possibly
cause serious injury
Fig. 1
To charge the battery, plug the
magnetic end of the charging
cable into the matching
receptacle on the base of the
screwdriver handle
Fig. 4
Fig. 2
Fig. 1
1
2
Fig. 3
Fig. 5
1 2
1
2
Fig. 6
