19
Revision date: 12.30.16
Photo shows installation of end bay sidewall diagonal
cable assemblies with turnbuckles at the lower end.
Diagonal Cable Installation
Using the diagrams and photos, install diagonal cables at each end bay of the frame. Position turnbuckle either at the
top end of the cable assembly as shown in the Quick Start diagrams, or at the bottom end (for easier adjustment) as
shown in the photos on the next page.
Secure each band clamp to the rafter using a Tek screw.
Install Tek screw in a location that will not contact film
cover when it is installed. Apply duct tape over band clamp on top of rafters to protect film.
Complete these steps:
1. Consult the
Cable Assembly table
above
(also found in the Quick Start guide) and
choose a cable for the
end bay sidewall
location. Verify on-center rafter spacing to
ensure correct cable is selected.
2. Construct a cable assembly using the
components shown in the cable diagrams
above. Ensure shackle is tighten after
installation.
3. Fully open turnbuckle. Threads of threaded
jaw should remain fully in turnbuckle body
when properly opened. See below.
AS2167
Anchor
Shackle
PGBRKAAS01
Bracket
104189 Turnbuckle
Turnbuckle
Cable
Cable
Shackle
PGBRKAAS01
Bracket
PGBRKAAS01
Bracket
End of Rod
Body
CABLE ASSEMBLY PART NUMBERS (30' WIDE)
END BAYS (SIDEWALL)
CAB25G0702
MID BAYS (ROOF)
CAB25G1706
