6
Revision date: 01.28.20
DOUBLE TWIN-WALL DOOR ASSEMBLY (continued)
15. With assistance, set assembled doors in door frame
and secure hinges to door jamb
using one Tek screw
per hinge at this time
. Locations of hinges may vary.
11. Mark plate mounting hole locations on panel and drill
a 5/16" hole through panel and door frame. Support
frame with a block of wood if needed.
12. Slide back mounting plate into position, align it with
mounting holes and front plate and secure using two
(2) ¼" x 3" bolts and lock nuts. Verify that latch turns
freely. Mount
door latch guide
(slotted plate) using
the remaining ¼" x 3" bolts. Position so latch handle
is level. See below.
Horizontal
Position
Door Latch
Guide
Latching
Plate
16. Verify there is sufficient clearance along all door
edges to allow door to swing freely in the opening.
17. Test door operation, adjust hinges as needed, and
install remaining Tek screws.
18. Attach the 6" chain bolt to inside, upper corner of
the
door without the handle
(see X in drawing below).
13. After assembling doors, evenly space three (3)
hinges along door frame of each door and attach
hinges to each assembled door using Tek screws
Inside
View
Outside
View
Door
without
handle.
X
14. Check door opening dimensions. Ensure rough door
opening is 1/2'' taller than doors and 1/2'' wider than
width of both doors.
Measure assembled doors for an
exact dimension.
19. Mount latching plate to outside of same door (see
drawing in step 12).
Screws supplied with latch are
not used for metal jambs
.
12"
Door Frame Assembly
