ECO GROW • Setup:
1. Main Unit
2. Inlet tubing with garden hose
connector
3. Sediment filter
4. Green coconut carbon filter
5. Outlet tubing
6. Shut-off valve
NOTE:
A flow restrictor is built into the brass connecting fitting between
the two housings. This gives optimum contact time for maximum
contaminant removal.
Before Installation/Precaution!
*Note:
Do not install the system where the incoming water pressure may
be more than 90psi (6 k/cm2). If unsure, check the pressure with a pressure
gauge, available at your local hardware store. If your water pressure is
more than 90psi (6 k/cm2) install a pressure regulator, available at your
Grow Max Water dealer or hardware store. Do not use with hot water.
How to install the ECO GROW unit:
1.
Begin by connecting the garden hose adaptor to your garden hose
or garden tap.
2.
Then take a length of 1/4" tubing (cut your desired amount) and push
one end into the other garden hose adaptor and the other end into the
"feed" inlet port of the filter system on the right side.
3.
Push the desired length of tubing into the "outlet" port of the filter
system on the left side. Decide where you want to install the inline
shut off valve and cut the tubing at that point. Simply push the two
lengths of tubing into the shut off valve and you are ready to go.
4.
Before using the system you will need to flush out any carbon fines
and particulates. You simply open the water and flush out the system
for 5 minutes letting the water go to the drain.
You are now ready to use your system!
1
2
3
4
5
6
