Copyright 2022 – Grove Audio LLC
All rights reserved
10
bootloader client is described below:
1. Move the entire folder called "usb_bootloader_client_win" to the host machine. It is not necessary to
install the bootloader client.
2. The module must be powered and the miniB USB connector on the module main board must be
accessible.
3. Move the jumper block on pin 8 of the 8pin MTA-100 connector in the upper left corner of the main
board so that pins 7 and 8 are connected. This enables the on-board programming mode.
4. Power up the module. The LED D3 should light steadily to indicate the module is ready to
communicate with the HID bootloader client.
5. Open the bootloader client folder and find the file HIDBootloader. Double click this file to run it.
6. Connect a USB type A cable from the host computer and plug the miniB end of the cable into the USB
connector on the module. There may be some preliminary communication and installation of drivers.
Eventually, a message should appear on the status window of the bootloader client indicating that a
device has been detected and is ready to install files. The LED D3 on the module will flash periodically to
indicate that it is ready.
7. Click on the file menu tab and select Import Hex file option.
8. When a file dialog window opens, navigate to the location of the module hex file to be loaded.
9. Once the file is successfully imported, click on the Program tab and select the Erase, Program, Verify
option.
10. Status messages indicating the progress of the transfer should appear.
11. Once the transfer is completed, power down the module.
12. Move the jumper from pins 7 and 8 to pin 8.
13. Power up the module and the new program version should start running.
