Grouser Products Ag Pro Plus, Руководство пользователя и каталог запасных частей

Страница: 4 / 24

4
Assembling Lift Components
Some assembly of Lift system components is necessary. Follow the steps listed below. Refer to Page 5 for the correct
hardware and orientation of parts.
Remove all pins and fasteners on each side of the undercarriage and set aside for later installation.
Position the lift frame between the two plates on both sides of the undercarriage and align to the bottom holes.
Attach the lift frame, the base end of the lift cylinders, and the top arms to the undercarriage. Refer to Page 5 for
proper components and orientation.
Attach the male quick attaches to the lift frame, and to the top arms. See Page 5 for proper orientation.
Tighten all fasteners.
Connect the lift hoses to the lift cylinders. The hoses are marked with 2 Orange Bands for the base end and 1
Orange Band for the rod end.
Verify that hoses are not twisted and protected from rubbing on any sharp edges. See picture below for proper
hose routing.
1.
2.
3.
4.
5.
6.
7.
Unpacking Components
Unstrap and remove the lift frame, hoses, top arms, and any boxes of hardware from the undercarriage. If any components
are missing, call Grouser.
Undercarriage Installation
Install undercarriage per the tractor specific mounting instructions.
Installing Hydraulic Coupler Components
Note: Refer to Diagram on Page 6 for further information on hose routing and hose positions. The quantity
and location of the female couplers is determined by blade functionality.
Attach the coupler mounts to the left top arm and install the female quick couplers and 90° fittings.
Install each coupler into the designated hole on the coupler mount and fasten them in place with the coupler retainer
plate, 3/8” x 3/4” bolts and 3/8” flange nuts.
Identify each remaining hose at the front of the undercarriage by the colored bands on the end of the hose and
connect the hose to the corresponding 90° fitting and female coupler in the coupler mount.
If applicable, attach the wire harness to the coupler mount. Hold in place with a zip tie. Run the other end of the wire
harness up into the cab of the tractor.
Locate the keyed and fused power supply. Connect the red wire to the power and the black to the ground. Install
provided switch into an open switch hole in the right overhead console or another convenient place in the tractor.
Connect the wire harness to the switch.
Continue on Page 7 for instructions on how to remove the air from the system.
8.
9.
10.
11.
12.
13.
14.