Groundsman TMC48, Руководство оператора

Страница: 17 / 24

CUTTER BLADE
Check for wear and tighten the mounting bolts:
It is important not to allow the cutter blade to become
loose
The three blade mounting bolts ’A’ should be checked and
tightened five working hours after initial fitting and every 30
working hours there after. On a level surface, tilt the machine
forward to rest on the front chassis nose and use the tee
wrench supplied to tighten the bolts.. If the cutting edge on
the cutter blade cross knife or side knives is rounded and dull,
the blade should be removed for sharpening. This should be
done by a service workshop. The cutting bevel should be
ground on the upper face of the blade cross knife and on the
outermost faces of the side knives.
If the blade cross knife is worn to less than 2/3 its original
width it will not enter the ground efficiently and must be
replaced.
Page 16
Running Maintenance
A
E
D
A
C
ADJUST
UP
B
GOUND DRIVE LEVER ADJUSTMENT
After the first 20 hours working and then every 300
hours
adjust the Ground Drive Lever...
1. Place the machine on a flat level surface
2. Engage ground drive lever (A) as shown
3. Slacken clamp bolt (B) and slide the lever bracket (C) up
wards on the bolt slot (D)
4. Hold the lever bracket (C) upwards as far as possible and
tighten clamp bolt (B) FIRMLY
5. When the ground drive worm gear is new, front wheel (E)
should have no backlash movement when lever (A) is
engaged in drive.
MAINTENANCE SUMMARY
Frequency Operation Type / Quantity
Blade 30 hrs Tighten Mounting Bolts Use Tee Wrench
Oil Can 30 hrs See page 15 Penetrating Oil
Grease Gun 100 hrs See page 15 General Purpose Grease
Blade 40 hrs Sharpen or Replace if Worn See page 16 (above)
Air Filter 50 hrs Clean or Replace See Honda Manual
Engine Oil 80 hrs Top Up SAE 10 W 30
Main Belt 100 hrs Adjust or Replace See parts manual
Blade Drive Belt 300 hrs Adjust or Replace See parts manual
Gear Oil 300 hrs Top Up EP 90
Gear Lever 300 hrs Adjust See page 16 (above)