Ground Zero RADIOACTIVE Series, Руководство пользователя

Страница: 4 / 8

Controls and functions
1 Input level controller With this controller you can adjust the input sensitivity.
2
Subsonic controller
This controller allows you to filter low frequencies in a range between
15 and 25 Hz. This function reduces the mechanical Xmax and raises
the capacity of the connected subwoofer.
3 Low pass controller
Adjust the variable lowpass frequency to the desired frequency
between 40 and 400 Hz using the controller.
4 Remote volume control
On – If the bass remote controller is connected
Off – If the bass remote controller is not connected
5 Bass boost controller For adjusting of the bass boost level in the range from 0 to +12 dB.
6 Phase shift controller
This controller allows you to fit the subwoofer channel in-phase to
the front system.
7 Status indication
GREEN – OK
RED – Error
8 High / Low switch Switch between high and low level (RCA) input.
9 Main connector
Pin 1: GND -> Ground connection (Black)
Pin 2: GND -> Ground connection (Black)
Pin 3: REM -> Remote – on (Red thin)
Pin 4: REM Vol (-) -> Bass remote (Orange/White)
Pin 5: Input left -> Positive signal input L (White)
Pin 6: Input right -> Positive signal input L (Grey)
Pin 7: BATT -> Input power 12 Volt (Red thick)
Pin 8: GND -> Ground connection (Black)
Pin 9: > Positive speaker output SUB (Yellow)
Pin 10: OUTPUT -> Negative speaker output SUB (Darkblue)
Pin 11: REM Vol (+) -> Bass remote (Orange)
Pin 12: Input left -> Negative signal input L (White/Black)
Pin 13: Input right -> Negative signal input L (Grey/Black)
Pin 14: BATT -> Input power 12 Volt (Red thick)
1
7
8