4
PARTICULAR WHEN STEREO SIGNAL ARE WEAK. IT IS PREFERABLE TO RECEIVE THE PROGRAM IN
MONO.
SET THE FM MODE SELECTOR (9) AT “FM-ST” POSITION FOR RECEIVING STEREO PROGRAMS. THE
FM-STEREO LED INDICATOR (10) WILL LIGHT UP TO SHOW FM STEREO PROGRAM IS RECEIVING.
HINTS FOR BEST RECEPTION:
-
-
FM : THE RECEIVER HAS A BUILT-IN FM WIRE ANTENNA (15) HANGING AT THE REAR CABINET. THIS
WIRE SHOULD BE TOTALLY UNRAVELED AND EXTENDED FOR BEST RECEPTION.
PHONO
NOTED:
-
REMOVE THE STYLUS PROTECTOR.
-
BE SURE THAT THE TONE ARM IS BEING DETACHED FROM THE TONE ARM
REST BEFORE OPERATING AND RE-SECURED AGAIN AFTERWARDS.
1. SELECT TO “ PHONO ” FUNCTION (5).
2. SET THE SPEED SELECTOR (12) TO THE PROPER POSITION DEPENDING ON THE
RECORD TO BE PLAYED.
3. PLACE THE RECORD ON THE PLATTER (USE THE SPINDLE ADAPTOR (11) IF
REQUIRED).
4. LIFT THE TONE ARM FROM THE REST (13) AND SLOWLY MOVE IT TO THE RECORD
SIDE. THE PLATTER WILL START TO ROTATE.
5. PLACE THE TONE ARM TO THE DESIRED POSITION OF THE RECORD.
6. ADJUST THE VOLUME (4) TO THE DESIRED LEVEL.
7. AT THE END OF RECORD, THE PLATTER WILL AUTOMATICALLY STOP ROTATING. LIFT THE TONE ARM
FROM THE RECORD AND RETURN IT TO THE REST.
8. TO STOP MANUALLY, LIFT THE TONE ARM FROM THE RECORD AND RETURN IT TO THE REST.
REMARK
: AT SOME OF THE RECORD, THE AUTO-STOP AREA IS OUT OF THE UNIT SETTING, SO IT WILL
STOP BEFORE THE LAST TRACK FINISH. IN THIS CASE, SELECT THE AUTO-STOP SWITCH (16) TO “ OFF
“ POSITION, THEN IT WILL RUN TO THE END OF THE RECORD BUT WILL NOT STOP AUTOMATICALLY (TURN
OFF THE UNIT BY POWER BUTTON OR SWITCH BACK THE AUTO-STOP SWITCH TO “ ON “ POSITION TO
STOP THE PLATTER TO ROTATE). THEN PUT BACK THE TONE ARM TO THE REST POSITION.
STYLUS (NEEDLE) REPLACEMENT
Replacement of a worn stylus can be easily accomplished as follows.
1. Raise the "Tone Arm".
2. To remove stylus, pull out the stylus assembly in direction shown(1)(2), holding the head shell with
your other hand.
3. Then install the new stylus by pushing it gently into the cartridge(3)(4) (hold by the sides to prevent
damage to stylus) until it clicks into place.
When the stylus eventually needs replacing, a replacement stylus is available for purchase directly from
the manufacturer: www.groov-e.co.uk or call +44 (0) 20 8839 0971 for more information.
LINE OUT CONNECTION
YOU CAN CONNECT THE SYSTEM TO YOUR HOME STEREO SYSTEM, OR AN EXTERNAL HI-FI / AMPLIFIER
SYSTEM BY CONNECTING THE RCA LINE OUT SOCKET (14) TO THE AUXILIARY INPUT SOCKET ON YOUR
HOME STEREO / HIFI / AMPLIFIER SYSTEM USING RCA CABLES (NOT INCLUDED).
