background image

1

English

Application 

Operation is possible in conjunction with:

- Pressurized storage heaters
- Thermally controlled instantaneous heaters
- Hydraulically controlled instantaneous heaters  

Operation with low-pressure storage heaters 
(displacement water heaters) is not possible.

Specifications 

Max. flow      

     9.5 L/min or 2.5 gpm/80 psi
     8.3 L/min or 2.2 gpm/60 psi

Flow pressure   
- min.                                       

7.25 psi

- recommended                         

14.5 - 72.5 psi

- greater than 72.5 psi, fit pressure 
  reducing valve

Max. operating pressure                      

145 psi

Test pressure                                

232 psi

Temperature    
- max. (hot water inlet)                      

176 

°

F

- handle rotation stop available, 
  (order no. 46 308)

 Water connection                                    

hot - LH

         cold - RH

Non reversible cartridge

Note
Major pressure differences between hot and cold 
water supply should be avoided.

Installation

Flush pipes thoroughly.

Mount faucet on basin

See dimensional drawing fold-out page I.

For installation you require only a 13mm (1/2’’) socket 
wrench, see fold-out page III, fig. [1].

Connect faucet

For this purpose the supply hoses must be connected 
to the angle stops (or other supply points), see figs. [1] 
and [2].

The hot water supply should be connected on the left, 
the cold water supply on the right side.

Avoid cross connection. The cartridge is not 
reversible.

Fit pop-up drain (28 957), see fold-out page II, ensure 
that flange of pop-up drain is sealed.

Open angle stops and check faucet for correct 
function,
 see fig. [3].
Lift lever 

= open (water flow)

Press lever down

= closed (off)

Move lever to right 

= cold water 

Move lever to left 

= hot water

Check connections for leakage.

Flow rate limiter

This mixer is fitted with a flow rate limiter, permitting an 
infinitely individual variable reduction in the flow rate. 
The highest possible flow rate is set by the factory 
before despatch.

Please proceed as follows to limit flow:
1. Strip lever lower part (A), see fig. [4].
2. Loosen set screw (B) using a 3mm (1/8’’) socket 

spanner, see fig. [5].

3. Pull off lever (C).
4. Unscrew cap (D).
5. Change flow rate by turning hexagon socket screw 

clockwise with a 1.5mm socket spanner. Turn clock-
wise (to reduce flow) or anticlockwise (to increase 
flow), see fig. [6].

Assemble in reserve order.

Maintenance

I. Cartridge, see fig. [5].
1. Shut off the hot and cold water supply!
2. Strip lever lower part (A).
3. Loosen set screw (B) using a 3mm (1/8’’) socket 

spanner.

4. Pull off lever (C).
5. Unscrew cap (D). 
6. Remove screws (E) and detach complete 

cartridge (G).

7. Change either the complete cartridge (G) or

seals (G1).

Assemble in reserve order.
Make sure that the cartridge seals (G1) engage in the 
grooves on the housing. Fit screws (E) and tighten 
evenly and alternately.

II. Flow regulator, see fold-out page II.

Unscrew and clean flow regulator (13 955).

Assemble in reverse order.

Inspect and clean all parts, replace as necessary and 
grease with special grease (order no. 18 012).

Replacement parts, see fold-out page II  ( * = special 
accessories).

Care

Instructions for care of this single lever faucet will be 
found in the Limited Warranty supplement.

The use of flow rate limiters in combina-
tion with hydraulic instantaneous water 
heaters is not recommended. 

974991.book : i97499us.fm  Seite 1  Dienstag, Mai 25, 1999  3:54 PM

Содержание Europlus 33 170











Отзывы: