Grizzly T32961, Инструкция по эксплуатации

Страница: 3 / 12

The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage.
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Machine Base
Workbench
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Figure 6. "Through Mount" setup.
Figure 7. "Direct Mount" setup.
Machine Base
Workbench
Lag Screw
Flat Washer
Another option is a "direct mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
Mounting Surface
Handle Crank
Mounting
Surface Edge
Figure 5. Handle crank clearing mounted
surface.
Model T32961 (Mfd. Since 9/21)
-3-
Mounting
Number of Mounting Holes ............................. 4
Diameter of Mounting Hardware .................
5
⁄
16
"
IMPORTANT: This machine MUST be mounted
on the edge of a workbench or wall in order for
the handle crank to clear the mounting surface
during operations (see
Figure 5). When mounting
to a workbench surface, verify that the workbench
is sturdy enough to support the full weight of the
Model T32961 with the heaviest possible work-
piece without tipping over. Consider mounting
the workbench to the floor to prevent tipping, if
needed.