Grizzly T32795, Инструкции

Страница: 2 / 4

-2-
Model T32795 (Mfd. Since 07/21)
Using Jig
Attach the jig support to the tool rest on your
Model T32720 10" Wet Grinder to sharpen scis-
sors, shears, and clippers.
To use jig:
1. DISCONNECT GRINDER FROM POWER!
2. Install tool rest in vertical position so it is
about 1" away from grinding wheel.
3. Slide jig onto tool rest and secure with (2)
M6-1 x 22 knob bolts (see
Figure 3).
Eye and face injuries and respiratory prob-
lems can occur while operating this tool.
Wear personal protective equipment to
reduce your risk from these hazards.
Keep hair, clothing, and
jewelry away from mov-
ing parts at all times.
Entanglement can result
in death, amputation, or
severe crushing injuries!
Figure 3. Jig installed on tool rest.
x 2
Tool Rest
Jig
4. Loosen (2) clamp knobs on clamp enough to
allow one blade of scissors or shears to slide
in (see
Figure 4).
5. Loosen (2) lock knobs on clamp enough so
they do not extend through upper portion of
clamp (see
Figure 4).
Lock Knob
(1 of 2)
Clamp Knob
(1 of 2)
Figure 4. Clamp components.
6. Insert (1) blade of scissors or shears into
clamp, as shown in Figure 5, and tighten
clamp knob to secure.
Note: If blade extends to second triangle
clamp, tighten both clamp knobs.
7. Tighten lock knob to secure (see Figure 5).
Note: If blade extends to second triangle
clamp, tighten both lock knobs.
Figure 5. Example of scissor blade secured in
clamp.
Clamp Knob
(1 of 2)
Lock Knob
(1 of 2)
Triangle
Clamp
(1 of 2)