Grizzly T32719, Руководство пользователя

Страница: 16 / 28

-14-
Model T32719 (Mfd. Since 06/21)
Aligning Fingers
To help ensure the bend is even along its length,
the clamping fingers must be parallel with the
clamping surface and bending block.
Item(s) Needed: Qty
Hex Wrench 8mm .............................................. 1
To align clamping fingers:
1. Lower clamping leaf until clamping fingers
just touch clamping surface (see Figure 11).
2. Look closely along bottom edge of each fin-
ger to determine if any are out of alignment
with clamping surface and bending block, as
shown in
Figure 11.
The clamping fingers can be spaced apart for
clearance when making pans or boxes. This
requires removing one or more of the fingers, so
that you can space the others to match the inside
width of your pan or box.
Spacing Fingers
Figure 10. Example of finger spacing.
Item(s) Needed: Qty
Hex Wrench 8mm .............................................. 1
To space clamping fingers:
1. Loosen cap screw on each finger you need to
remove.
2. Remove fingers and toe clamps from clamp-
ing leaf, as shown in Figure 10, and set them
aside.
Note: You may need to mix and match finger
widths to match the inside width of your pan
or box.
3. Align remaining fingers and tighten cap
screws.
3. Loosen cap screw on misaligned finger just
enough to move it up or down.
4. Align finger parallel with clamping surface
and bending block, and then tighten cap
screw.
aligning fingers
Figure 11. Example of a misaligned clamping
finger.
Clamping
Surface
Bending
Block
This Finger is
Misaligned
Finger
Toe
Clamp