Grizzly T32057, Руководство по сборке

Страница: 2 / 8

Jointer knives are extremely sharp. You
must remove the jointer knives, or mount
the knives blade side down to avoid the risk
of serious personal injury during the follow-
ing steps.
Figure 2.
Example of jointer disassembly
Steps
1– 4.
Figure 3. Example of removing hex nut and flat
washer on bearing block stud.
Figure 4.
Example of cutterhead removed.
Bearing
Block Stud
Bearing
Block
-2-
T32057 8" Helical Cutterhead Assembly
5. Remove nut and flat washer on bearing block
stud, as shown in Figure 3, and repeat on the
other side.
6. Wearing heavy leather gloves, carefully
remove the cutterhead from the casting (see
Figure 4).
Note: Your cutterhead may have paper shims
stuck to the bearing block or where the bear-
ing block rests. These were included at the
factory when they calibrated your cutterhead
to be even with the outfeed table. Your new
cutterhead may or may not need these. If
you see any shims, carefully pull them off
and set them aside for later use—or keep
them with your cutterhead in the event that
you re-install it later. Also, mark the side of
the cutterhead where they were used, so the
future install will go smoothly.
7. Remove bearing block studs from bearing
blocks.
Removing Existing Cutterhead
1. DISCONNECT MACHINE FROM POWER!
2. Remove jointer fence, cutterhead guard, and
rabbeting table.
3. Remove rear access panel and belt cover,
then remove V-belt from pulleys.
4. Lower both tables to make enough room for
the cutterhead to come out (see Figure 2).
Note: When lowering, make sure that the
fence support does not come in contact with
the cutterhead pulley.