Model T32004 (Mfd. Since 02/20)
-15-
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine.
The Test Run consists of verifying the following: 1)
The motor powers up and runs correctly.
3. Connect machine to power supply.
4. Press ON button (I) to turn machine ON.
5. Verify motor operation by slowly turning
spindle speed dial clockwise. Rotate dial
back and forth to test variable-speed func-
tion. Motor should run smoothly and without
unusual problems or noises.
— If motor does not run smoothly, imme-
diately turn machine
OFF and discon-
nect power. Refer to
Troubleshooting on
Page 23 before operating.
6. Turn spindle speed dial all the way counter-
clockwise to ensure machine does not unex-
pectedly start in highest speed, then press
OFF button to turn machine
OFF.
Congratulations! Test run is complete.
2. Press OFF button (O) and turn spindle
speed dial all the way counterclockwise (see
Figure 11) to ensure machine does not
unexpectedly start in highest speed.
Figure 11. ON/OFF switch and variable-speed
dial locations.
Variable-Speed Dial
ON/OFF Switch
Содержание T32004
Страница 32: ......
