Grizzly T28930, Инструкция по эксплуатации

Страница: 3 / 8

Model T28930 (Mfd. Since 12/18)
-3-
Figure 6. Base mounted to workbench.
x 4
1. Mark workpiece for bend.
2. Insert workpiece between upper and lower
dies, with mark aligned to front edge of upper
die (see
Figure 9).
3. Pump brake handle up and down until desired
angle has been achieved.
Crushing hazard! Always
keep hands clear when
using this machine.
4. Release hydraulic pressure by loosening
release valve. Wait for lower die to fully lower
before tightening release valve and removing
workpiece (see
Figure 10).
Figure 10. Location of hydraulic release valve.
Release Valve
Figure 9. Workpiece aligned with upper die.
Workpiece
Upper Die
Lower Die
Mounting to Workbench
To mount to workbench:
1. Place machine on workbench in desired loca-
tion, then make drilling marks through holes
in the mounting brackets (see
Figure 5).
Figure 5. Drilling hole location.
Mark Drilling Hole
2. Set machine aside and drill holes for mounting.
3. Attach each base corner to workbench using
an M10-1.5 x 30 hex bolt, 10mm flat washer,
and M10-1.5 hex nut (see
Figure 6).
Tools Needed Qty
Drill ................................................................... 1
Drill Bit
7
⁄
16
" ........................................................ 1
Wrench or Socket 17mm ................................... 2
Operating Hydraulic Brake