Grizzly T28062, Руководство пользователя

Страница: 10 / 16

Model T28062 (Mfd. Since 08/17) -8
-
SECTION 4: OPERATIONS
Use low RPM settings when work-
ing with plastics or other materials
with low melting points. Melted
plastics can liquefy, be thrown into
the air, and stick to the operator,
causing serious personal injury.
To use rotary tool:
1. Make sure ON/OFF/Variable-Speed
Control dial is turned OFF.
2. Install a bit (see Page 9).
3. Insert AC adapter into a matching
power supply receptacle.
4. Grasp tool firmly. Make sure your
hands are clean and dry.
5. Turn ON/OFF/Variable-Speed Control
dial
ON and turn dial further to change
RPM.
Note: Start operation with low speed
and increase speed as needed.
6. Ease tool against workpiece using light
pressure.
Tips: Test bit and RPM combination
on a scrap piece of material similar
to workpiece. When using abrasive
cones, use tip of cone. Otherwise abra-
sive material may unravel.
The Model T28062 is best suited for high-
RPM, low-torque applications. Most opera-
tions performed with the tool will perform
best at higher RPM settings; however,
slower RPM settings are ideal when work-
ing with plastics that melt easily.
High RPM Uses
High RPM's are best for general carving,
cutting, routing, and grinding. The grinder
removes material more quickly at higher
RPM's.
Low RPM's are best for grinding and cut-
ting materials that have low melting points.
Plastics in particular often melt from the
heat generated by high-speed bits. Low
RPM's are also best for polishing and
buffing.
Low RPM Uses
Rotary Tool Use
The variable-speed control dial adjusts the
rotary tool speed between zero and 16,000
rotations per minute (RPM).
Variable-Speed Control Dial
ACCIDENTAL
START HAZARD!
Disconnect power
before servicing
or changing
accessories.
LUNG/EYE
INJURY HAZARD!
Wear a respirator
and safety glasses
when using this
tool.
To prevent injuries from tool slip-
page, always secure workpiece in
a vice or other clamping device.
Never hold the workpiece by hand
during operation.