Grizzly T27961, Руководство пользователя

Страница: 16 / 28

Model T27961 (Mfd. Since 02/17) -16
-
Benchtop Installation
To install sander on benchtop:
1. Place mounting pad flush along edge
of flat benchtop (see Figure 12) so
gripping side faces down. Place sander
upside-down on top of mounting pad,
then insert anchor bolts into holes on
sander body (see
Figure 12).
Note: Mounting pad features pre-
formed spaces to help orient sander.
2. Attach clips and wing nuts to anchor
bolts, and tighten until sander is
secured to benchtop (see
Figure 12).
The top of this tool has mounting holes
that allow it to be fastened to a workbench
with the included L-shaped anchor bolts,
wing nuts, clips, and mounting pad. This
prevents sander from moving during
operation, giving the operator the ability to
use it as a stationary tool.
Note: L-shaped anchor bolts allow for
mounting to tables from
3
⁄
4
"—4
1
⁄
4
" thick.
Figure 12. Sander installed on benchtop.
Soft Pad
Anchor Bolt
Wing Nut
Clip
3. To remove anchor bolts, loosen wing
nuts and wiggle sander/clamp jaws
until anchor bolts can be removed.
To use edge guide:
1. Begin sanding operation at one end of
workpiece with the face of edge guide
against workpiece. This way tool will
remove an even amount of material
(see
Figure 11).
Using Edge Guide
DO NOT remove excessive amounts
of material with sander. Excessive
force can cause damage to rubber
sanding drum.
2. Gradually feed sander along entire
edge opfworkpiece.
Figure 11. Sanding with edge guide.
Mounting
Holes