-2-
T27140 12" Heavy-Duty Bench Shear (Mfd. 1/15)
Description Qty
A. Bench Shear ............................................... 1
B. Work Stop Assembly .................................. 1
Inventory
Assembly
3. Use left hand to hold workpiece steady on
table and lower handle with right hand to per-
form cut.
The Model T27140 is equipped with a work stop
that makes it quick and easy for you to make
repeat cuts of the same size.
To use work stop:
1. Lift handle to open shear blades, then align
shear blades with cut line marked on work-
piece.
Using Work Stop
Figure 3. Location of work stop and knob.
2. Slide work stop against workpiece and tight-
en work stop knob (see
Figure 3).
3. For subsequent cuts, place workpiece on
table and slide against work stop, then pro-
ceed with cut.
Work Stop
Work Stop
Knob
The Model T27140 comes fully assembled, except
for the optional work stop assembly.
To install work stop, insert threaded end of work
stop rod into mounting hole on bench shear, and
tighten using 8mm wrench on flats of rod end (see
Figure 2).
1. Mark cut line on workpiece.
2. Lift handle to open shear blades, then align
shear blades with cut line.
Injury to your hands and fingers could
result from improper use of this tool. Never
place your hands or fingers in path of blade
while using this tool. Never use tool without
safety guard in place.
Operations
Figure 2. Work stop assembly installed.
Flats For Tightening
Work Stop
Rod
Mounting
Hole
