t23089 (Mfg since 11/10)
-7
-
changing cut-off Wheels
the Model t23089 uses 3" cut-off wheels
with a
3
⁄
8
" bore. see the grizzly catalog or
www.grizzly.com for a complete listing of
available cut-off wheels.
3. remove the cap screw that secures the
cut-off wheel, then remove the wheel.
4. place the replacement cut-off wheel
onto the arbor, then use the arbor
wrench and hex wrench to fully tighten
the flange, securing the new wheel.
to change the cut-off wheel:
1. disConneCt tool FroM Air!
2. position the arbor wrench on the flats
behind the inner arbor flange (see
figure 3).
figure 3. loosening the outer arbor
flange.
hex Wrench
Arbor
Wrench
Cap screw
an incorrect size wheel or one not
rated for at least 18,000 rpm will
not work properly with this tool and
could fly apart and cause operator
injury. always make sure to install
only 3" cut-off wheels with a
3
⁄
8
" bore
on this tool.