-2-
T10538 Drilling Set
Guide Setup & Operation
If using a handheld drill, always use the included
guide to keep the bit centered.
To set up and operate the guide:
1. Press guide down onto workpiece, then flip
lock levers, as shown in
Figure 2, to secure
guide down.
Figure 2. Model T10538 guide set up for drilling.
Bit
Lock
Lever
Plate
Lock
Knob
Guide Hole
2. Loosen lock knobs, then slide plate back
enough to pour a small amount of water into
guide hole.
3. Insert drill bit into guide hole and slide plate
cutout against outer edge of bit until snug,
then tighten the knobs. Use small cutout for
3
⁄
16
"–
1
⁄
2
" bits, or large cutout for
3
⁄
4
"–1
3
⁄
8
" bits.
4. Tug guide to ensure it is secure. If it moves,
unlock both lock levers and repeat
Steps
2–3.
5. Add water to guide hole as needed to main-
tain a slurry, and turn drill
ON to begin drill-
ing.
6. When drilling is complete, loosen lock knobs,
unlock both levers, and remove guide.
To remove plug from drill bit:
1. Spray water into access channels on side of
drill bit to remove built-up slurry.
2. Tap drill bit lightly against a soft piece of
wood to loosen plug.
3. Insert a flat head screwdriver into access
channels to push pug from drill bit.
Operation Tips
•
To reduce chip-out or breakage, place a
backing board to support the workpiece and
reduce pressure when finishing the hole.
•
Make sure the workpiece is clean and moist
so the suction cup grips the workpiece.
•
Use an eye dropper or spray bottle to add a
small amount of water to the drilling area (e.g.
1 teaspoon at a time). Avoid using oil-based
lubricants.
•
Harder materials may require a constant flow
of water to properly lubricate and keep drill bit
cool during use.
•
The amount of water required to properly
lubricate the bit depends on the porosity of
the workpiece. A good rule of thumb is to
start with a puddle of water approximately the
same diameter as the bit. Non-porous mate-
rial, such as glass or marble, may not need
additional water (depending on the thick-
ness). Porous material, such as slate or tile,
will slowly absorb water, which will require
replacement. Most importantly, never allow
the bit to run dry.
•
As the groove gets deeper, move the bit up
and down while drilling to allow water to flow
back into the cutting groove, cooling the bit.
Add water if the slurry become too thick.
•
Use minimal pressure while drilling to avoid
breaking the workpiece. Allow the drill bit to
do the work.
•
The drill bit should never be hot to the touch.
Decrease pressure, increase lubrication, or
change drilling speed to keep bit cool.
•
Always use the guide when drilling with a
handheld drill.
•
Never use the bits in an impact hammer.
Doing so will cause the tip of the bit to split
and shatter the workpiece.
•
Follow all safety and operation instructions
for your drill press or handheld drill. Avoid
exposing electrical equipment to water as
contact with water could cause electrocution.
