Model H8235 3-Piece Framing/Brad/Palm Nailer Kit
-15
-
CLEANING & LUBRICATION
Cleaning
Use non-flammable solvent to clean the
nose assembly of the nailer. Always be
sure that the nailer is dry before using it
again.
Do not allow dust, chips, sand, etc. into
the air connectors or into the body of the
nailer; this may result in leaks and damage
to the nailer and the air couplings.
Lubricating
Standard pneumatic tool oil has been
included with your new Grizzly nailer to
help maintain its useful life. Place two to
six drops of oil in the nailer air inlet (as
shown in
Figure 15
) before every use, or
after 2 hours of continuous use.
Wipe off any excess oil near the nailer
exhaust to avoid dust build-up. When the
oil that was included with the nailer has
been completely used, replace with Grizzly
Model G2820 Pneumatic Tool Oil.
Another option to manual oiling would be
to install a lubricator in your air compres-
sor line. If your air compressor line already
has a lubricator, then regular lubrication
of your nailer will not be necessary. Just
make sure there is always oil in the lubri-
cator.
Figure 15.
Lubricating nailer via air inlet.
Never clean this tool with gasoline
or other flammable liquids. Vapors
in the tool may ignite, causing the
tool to explode. Ignoring this warning
may lead to serious personal injury or
even death!
