Grizzly H7945, Инструкция по эксплуатации

Страница: 13 / 28

H7945/H7946/H7995 26° Angle Nailer
-11
-
A jammed nail must be cleared before the
nailer is used again.
To clear a jammed nail from the dis-
charge area:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Remove all nails from the magazine.
(See Unloading Nails on Page 9 .)
3. Use a pair of pliers to grab the
jammed nail and pull it from the nose
as shown in
Figure 9
.
Clearing Jammed
Nails
Figure 9. Using pliers to remove a
jammed nail.
Figure 8.
Depth adjustment knob.
Adjusting the depth of nail penetration is
done by turning the adjustment knob locat-
ed near the trigger as shown in
Figure 8 .
Adjusting Depth
To adjust the nail depth:
1.
DISCONNECT NAILER FROM THE
AIR SUPPLY AND POINT THE NAILER
IN A SAFE DIRECTION!
2.
Turn the depth adjustment knob to
increase or decrease nail penetration:
— If you want to increase the nail
depth, then turn the adjusting knob
counter clockwise.
— If you want to decrease the nail
depth, then turn the adjusting knob
clockwise.
3. Connect the nailer to the air supply,
test the nail depth, and repeat this
entire procedure if necessary until the
nail depth is satisfactory.
Depth Adjustment
Knob
Note:
If you cannot remove the jammed
nail in this way, then disassemble the
nailer's nose assembly to gain full
access to the nail, remove it and reas-
semble. Refer to the parts breakdown
drawing included in the back pages of
this manual for guidance during this
procedure.
4. Throw the damaged nail away and
insert a new strip of nails. DO NOT
use dirty or damaged nails!
Jammed Nail