Introduction
Heavy-duty industrial air drill features paddle
switch for easy control, a
3
⁄
8
" Jacobs
®
chuck, rear
air exhaust and rugged aluminum body. It has a
22,000 RPM free speed with 4 CFM average air
consumption.
A.
Industrial Air Drill ........................................ 1
B.
3
⁄
8
" Jacobs
®
Chuck ...................................... 1
C
. Chuck Key .................................................. 1
D.
Wrench ....................................................... 1
Operation
Screw the chuck on the arbor and tighten with the
wrench provided. Add a
1
⁄
4
" MNPT air fitting and
connect to your regulated compressed air supply.
Do not exceed 90 PSI!
MODEL H6194
3
⁄
8
" INDUSTRIAL AIR
DRILL
INSTRUCTION SHEET
Figure 1.
Model H6194.
Figure 2.
Lubricating directly into air fitting.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPYRIGHT © APRIL, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8030 PRINTED IN CHINA
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EXPLOSION HAZARD!
Never exceed 90 PSI!
EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection during
use of this tool!
This industrial air drill MUST have 3-4 drops of oil
directly dropped into the air fitting before each use
as shown in
Figure 2
.
