Grizzly G9729, Инструкция по эксплуатации

Страница: 40 / 80

-38-
G9729 Combination Lathe/Mill
Figure 40.
Half nut lever disengaged.
Half Nut
The half nut lever is located under the left hand
side apron (
Figure 40
). This handle may be
engaged and disengaged while the machine is
running and while making a cut. Move the lever
to the down position to engage the half nut.
Because the threads of the nut and leadscrew
will not always be aligned, engaging the half
nut may require waiting until they align, with the
machine running. Lift the handle in the direction
of the arrow as shown in
Figure 40. DO NOT
force the handle, apply light pressure to the han-
dle and when the threads are aligned the handle
will engage.
Apron Power Feed
Figure 41.
Apron controls.
The apron power feed is designed to make work
more efficient, provide better surface finishes and
aid in cutting threads.
• Once the proper gears have been installed,
(see
Changing Gears
on
Page 39)
and the
feed rate selected, power to the apron and
cross slide is provided by the leadscrew,
shown in
Figure 41 .
• In the case of the apron, motion starts by
engaging the half nut lever, shown in
Figure
40 .
• In the case of the cross slide, a ring is pulled
out, as shown in
Figure 41
.
DO NOT try to engage the half nut & cross
slide ring at the same time. While there is
a lock-out provided against simultaneous
engagement, these components could be
damaged if proper procedures are ignored.
NOTICE
Half Nut Lever
Cross Slide Ring
Leadscrew