g9249 12" x 37" Belt drive gap Bed lathe
-47-
Lubrication
your lathe has numerous moving metal-to-metal
contacts that require proper lubrication to help
ensure efficient and long-lasting operation.
other than lubrication points covered in this sec-
tion, all other bearings are internally lubricated
and sealed at the factory. simply leave them
alone unless they need to be replaced.
Before adding lubricant, clean away any debris
and grime from the lubrication point to avoid con-
taminating the lubricant and increasing wear of
the moving parts.
disConneCt the lAthe FroM poWer
BeFore
perForMing
luBriCAtion
proCedures!
Spindle Bearing Oil
Lubricant
frequency
Qty
iso 68 sAe 20W
Bearing and gear
lubricant
every
8 hours
of operation
Fill to half
on sight
glass
To add oil to the spindle bearing reservoirs:
1. raise the headstock cover, then remove the
oil plugs shown in
figure 78.
NOTICE
follow reasonable lubrication practices as
outlined in this manual for your lathe. failure
to do so could lead to premature failure of
your lathe and will void the warranty.
figure 78. spindle bearing reservoir oil plugs.
oil plugs
2. Fill both spindle bearing reservoirs with oil
until the oil level in the sight glasses shows
at least half-way (see
figure 79).
figure 79. spindle bearing reservoir oil sight
glasses.
sight glasses
3. Clean away any spilled oil, replace the oil
plugs, and lower the headstock cover.
To change the spindle bearing oil:
1. start the spindle rotation and let it run for
approximately 20 minutes to warm up the
oil.
2. remove the oil plugs shown in figure 78.
3. remove the oil sight glasses shown in figure
79, then completely drain the spindle bearing
oil reservoirs.
4. replace the oil sight glasses, and re-fill the
reservoirs as instructed in the previous sub-
section.
Содержание G9249
