assembly
to assemble the cart:
1. slip the struts onto the axle shaft in the posi-
tion shown in
figure 2, and secure the struts
and tag axle support to the frame with six
M8-1.25 x 18 hex bolts, 8mm flat washers,
and M8-1.25 locking nuts.
5. secure the tie bar to the steering axle and
fasten the axle assembly to the frame with
four M8-1.25 x 18 hex bolts, 8mm flat wash-
ers, and M8-1.25 locking nuts (
figure 3).
6. slide two wheels onto the axles, and secure
each in place with a 12mm flat washer, lock
washer, and the acorn nut (
figure 3).
7. insert the handle into the handle joint, then
insert the joint into the receiver. secure the
assembly in place with the M8-1.25 x 60 hex
bolt, 8mm flat washer, and M8-1.25 locking
nut (
figure 4).
8. When completely assembled, position the
cart tow handle in the up position (
figure 5)
to avoid any tripping hazards.
figure 5.
top shelf.
9. Make sure the tires are inflated to the pres-
sure indicated on the tire sidewall. if inflation
is required, only use a hand pump. do not
UsE high prEssUrE shop air, or
tirE EXpLosion CoULd oCCUr!
figure 4.
tow handle.
handle
Joint
receiver
tow handle
figure 2.
tag axle and wheel installation.
2. slide two wheels onto the axles, and secure
each wheel to the axle with a 12mm flat
washer, 12mm lock washer, and the M12-
1.75 acorn nut (
figure 2).
3. Connect the receiver and the center strut to
the steering axle with one M8-1.25 x 25 hex
bolt, 8mm flat washer, and M8-1.25 locking
nut (
figure 3).
4. place the 10mm flat washer onto the king pin
and retain it with the cotter pin (
figure 3).
strut
tag axle
shaft
tag axle
support
figure 3.
steering axle.
receiver
tie Bar
Center strut
King pin, Washer,
and Cotter pin
