Grizzly G0893, Руководство пользователя

Страница: 26 / 53

Model G0893 (Mfd. Since 03/19)
-19-
Dust Collection
To connect dust collection bag:
1. Fit dust collection bag over dust port, as
shown in Figure 18, and secure with bag
clamp.
Recommended CFM at Dust Port: 250 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
2. Tug bag to make sure it does not come off. A
tight fit is necessary for proper performance.
Note: Dust collection bag may be substituted
with an appropriately-sized dust collector with
2
1
⁄
2
" dust collection hose (see above).
Figure 18. Securing dust collection bag with bag
clamp.
Bag
Clamp
9. Use (2) M8-1.25 x 30 cap screws, (2) 6mm
lock washers and (2) 6mm flat washers to
attach each handle to each end of the jointer
tables (see
Figure 17).
Figure 17. Handle attached to end of table.
x 2
Table
Handle
Jointer
Table