Grizzly G0795, Руководство пользователя, Страница: 36 / 64

-34-
Model G0795 (Mfd. Since 02/15)
4. Place a 1-gallon or larger drain pan on table
under headstock.
5. Remove drain plug (see Figure 48) and allow
oil to drain into pan.
Follow federal, state, and local require-
ments for proper disposal of used oil.
6. Replace drain plug.
7. Add oil until sight glass is halfway full, then
replace fill plug.
8. Clean up any spilled oil to reduce slipping
hazards.
Figure 48. Location of headstock drain plug
(headstock tilted 90° for clarity).
Drain
Plug
Lubrication
Tools Needed Qty
Wrench 24mm ................................................... 1
Hex Wrench 6mm .............................................. 1
Drain Pan (1-Gallon or larger) ........................... 1
To change headstock oil:
1. Run spindle at 600 RPM for approximately 10
minutes to warm oil.
2. DISCONNECT MACHINE FROM POWER!
Lubrication Frequency
Lubrication Task Frequency Page
Ball Oilers Daily 35
Table Leadscrew Daily 36
Headstock Annually
34
Column Nut & Pinion Annually
37
Quill Outside Surface Daily
36
Quill Rack & Pinion Annually 37
Table & Column Ways Daily 35
This mill/drill requires regular lubrication to main-
tain smooth movement and ensure long-lasting
operation. Components not covered in this sec-
tion are sealed and internally lubricated for life.
Before performing any lubrication task,
DISCONNECT MACHINE FROM POWER!
Figure 47. Headstock oil fill plug and sight glass.
Oil
Sight
Glass
Fill
Plug
3. Remove fill plug (see Figure 47).
Headstock
Lube Type ...Model T23962 or ISO 68 Equivalent
Lube Amount .............................................3
1 ⁄
4
qt.
Check/Add Frequency ........... 8 hrs. of Operation
Change Frequency ................................ Annually
The headstock has the proper amount of oil when
the sight glass shown in
Figure 47 is halfway full.