Grizzly G0784, Руководство пользователя

Страница: 25 / 48

Model G0784 (Mfd. since 03/15)
-23-
Note:
If using a collet, insert tooling into collet
before tightening drawbar. Be sure to protect
your hands from sharp tooling with leather
gloves or a shop rag.
6. Continue to tighten drawbar until collet and
cutter (or arbor) are snugged firmly in place.
Do not over-tighten drawbar and never use
power tools to tighten it.
—If drawbar bottoms out in tooling and will
not tighten further before tooling is tight
in spindle, tighten drawbar lock nut (see
Figure 17) to secure tooling in spindle.
This machine features a spindle that accepts R-8
collets and arbors. It can also use MT#3 or MT#2
tooling with the included adapter sleeves.
To install tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Open belt cover.
3. Make sure tapered mating surfaces of tooling
and spindle are clean and free of grease or
other contaminants.
4. Insert tooling arbor/collet into spindle hous-
ing, then rotate arbor/collet to align keyway
with matching pin in spindle opening.
5. Using lug wrench included with machine,
rotate top of drawbar clockwise (see
Figure
17) until drawbar threads mesh with female
threads arbor/collet.
Tip: If necessary, insert included drill chuck
key into chuck to hold chuck in place when
loosening drawbar.
Installing Tooling
1. DISCONNECT MACHINE FROM POWER!
2. Loosen, but do not remove, drawbar.
Tip: If necessary, insert included drill chuck
key into chuck to hold chuck in place when
tightening drawbar.
3. Hold tooling to prevent it from dropping com-
pletely out of machine. Tap on top of drawbar
with a brass hammer to loosen collet/arbor
from spindle, as shown in
Figure 18.
Removing Tooling
Figure 17. Threading drawbar into collet/arbor to
install tooling.
Arbor
Drawbar
Lock Nut
Lug Wrench
Drawbar
4. Unthread drawbar until it is free from tooling.
Remove tooling from spindle when not in use.
Figure 18. Tapping top of drawbar with drawbar
nut already loosened to remove tooling.
Arbor
Drawbar
Brass Hammer