-24-
Model G0771Z (Mfd. Since 01/21)
28
. Install end cap on right end of front fence rail
in the same manner as you did on the left end
(Step 7 on Page 21).
29.
Secure rear access panel with (6) Phillips
head screws.
30
. Mount dust port with (4) Phillips head screws
(see Figure 31).
Figure 31.
Dust port installed.
x 4
Figure 33.
Example of dust hose attached to
dust port.
Dust Collection
To connect a dust-collection hose:
1.
Fit 4" dust hose over dust port, as shown in
Figure 33, and secure in place with a hose
clamp
.
2.
Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper per-
formance.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust-collection "how-to" book.
This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
31.
Install miter guage handle and 6 x 20mm
washer See Figure 32.
Figure 32.
Miter guage handle and washer.
