Grizzly G0767, Руководство пользователя

Страница: 23 / 48

Model G0767 (Mfd. Since 1/14)
-21-
Replacing Abrasive
Belt
Whenever the abrasive belt becomes worn or
damaged, replace it. The Model G0767 uses a 4"
x 79" silicon-carbide abrasive belt (refer to
Page
28 for abrasive belts available from Grizzly).
Use coarser grit belts for fast cutting and hard
metals. Use finer grit belts for softer metals and a
smoother finish.
Tool Needed Qty
Hex Wrench 6mm .............................................. 1
To replace abrasive belt:
1. DISCONNECT MACHINE FROM POWER!
2. Pull belt tension lever up and toward front of
machine with one hand as you guide motor
forward with other hand (see
Figure 21). This
releases abrasive belt tension.
3. Loosen cap screw that secures belt cover
(see Figure 22), then open cover and remove
abrasive belt from machine.
Figure 21. Releasing abrasive belt tension.
Belt Tension
Lever
Figure 22. Belt cover opened.
Cap Screw
4. Place desired profile roller in support bracket
(refer to Replacing Profile Roller on next
page for detailed instructions).
5. Slide abrasive belt onto profile roller, drive
pulley, and over deburring platen so that
direction arrows stamped on inside of belt are
pointing in same direction as arrows shown in
Figure 23.
Note: Arrows on bottom inside of belt should
point to the right.
Figure 23. Correct installation and orientation of
abrasive belt direction arrows.
Drive
Pulley
Deburring
Platen
Profile Roller