Grizzly G0767, Руководство пользователя

Страница: 20 / 48

-18-
Model G0767 (Mfd. Since 1/14)
16. Remove the two pre-installed vise mounting
cap screws shown in Figure 15.
Figure 15. Vise mounting cap screws.
Cap
Screws
Vise
Mount
17. Position vise assembly on vise mount and
secure it with cap screws removed in
Step 16
(see Figure 16).
Figure 16. Vise assembly attached.
Cap Screws
18. Slide spark trap into grooves on right side of
machine, as shown in
Figure 17.
Figure 17. Spark trap positioned in grooves.
Spark Trap
Grooves
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.