Grizzly G0765, Руководство пользователя

Страница: 32 / 76

-30-
Model G0765 (Mfd. Since 5/15)
Turn
CCW Turn
CCW
Turn
CW
Turn
CW
Figure 31. Example of set screw adjustment in
relation to tailstock movement.
3. Tighten tailstock lock to secure the offset.
To offset the tailstock:
1. Loosen tailstock lock to release clamping
pressure on top and bottom castings.
2. Rotate adjustment set screws in opposite
directions for desired offset (see
Figure
below).
Tools Needed Qty
Hex Wrench 4mm .............................................. 1
Note: The marks on the offset indicator are arbi-
trary. For a precise offset, use a dial indicator to
check quill movement while adjusting the screws.
Aligning Tailstock to Spindle
Centerline
Figure 32. Turning a dead center.
This is an essential adjustment that should be ver-
ified or performed each time the tailstock is used
to turn concentric workpieces between centers
or immediately after offsetting the tailstock when
turning a taper. If the tailstock is not aligned with
the spindle centerline when it is supposed to be,
turning results will be inaccurate along the length
of the workpiece.
Items Needed Qty
Hex Wrench 4mm .............................................. 1
Round Stock 2" x 6" .......................................... 2
To align the tailstock to the spindle centerline:
1. Center drill both ends of one piece of round
stock, then set it aside for use in
Step 5.
2. Use the other piece of round stock to make
a dead center, and turn it to a 60° point, as
illustrated in the
Figure below.
Figure 30. Left offset adjustment.
Adjustment
Set Screw (1 of 2)
Offset
Indicator