Model G0758Z (Mfd. Since 02/17)
-3-
DRO Components
The X-axis sensor and scale are attached to the
table. The Y-axis scale is attached to the saddle,
and the Y-axis sensor is attached to the base.
The Z-axis sensor and scale are attached to the
column. Shielded cables run from each sensor
to plugs on the back of the DRO (see
Figure 2).
The DRO connects to a 110V power supply with
a dedicated power cord using a NEMA 1-15 plug.
Figure 1. DRO magnetically mounted to mill
headstock.
Model G0758Z features a magnetically mounted
DRO (see
Figure 1) for X-axis (table), Y-axis
(saddle), and Z-axis (column) travel.
Note: When placing the DRO, locate all cables so
they do not interfere with machine operation and
cannot be pinched by moving components.
Digital Readout
A. DRO displays current position of X-axis,
Y-axis, and Z-axis in hundredths of a millime-
ter or thousandths of an inch.
B. "X" value displays total X-axis travel from
zero along table.
C. "Y" value displays total Y-axis travel from
zero along saddle.
D. "Z" value displays total Z-axis travel from
zero along column.
E. In/MM button allows users to toggle
measurement display in either inches or
millimeters.
F. ZERO buttons reset values at any point along
the axis to 0.00.
G. Green light indicates inches or millimeters.
H. Magnetic mount.
Using the DRO
DRO
(Viewed from behind)
110 VAC
1-15 Plug
NEUTRAL
HOT
Z-Axis Sensor
Y-Axis Sensor
Z-Axis Port
Y-Axis Port
Power Cord
Port
POWER
X-Axis Port
X-Axis Sensor
CXM-3
Figure 2. G0758Z DRO wiring.
Figure 3. DRO controls and display.
B
D
G
A
H
E
C
F
Figure 4. DRO cable connections (rear).
Z-Axis
Port
ON/OFF
Switch
DRO Power
Cord
Y-Axis
Port
X-Axis
Port
Содержание G0758Z
Страница 4: ......
