-18-
g0659
9" x 14" Vertical Metal-Cutting Bandsaw
Angle Adjustments
1.
the lock pins secure the vise angle at 90º.
For angles other than 90º, remove the lock
pins from the vise. if they do not pull out by
hand, turn the lock nuts clockwise to release
the pins from their holes (
figure 18
).
C-Clamp Vise installation
1.
place the C-clamp vise over the vise base,
then insert the vise rod into the clamp base,
as shown in
figure 19.
figure 18.
Clamp vise angle.
lock pin
lock nut
Clamp lock
Bolt
2.
loosen the clamp lock bolt, rotate the clamp
to the desired angle, then tighten the clamp
lock bolt.
Clamp Vise
2.
turn the leadscrew to tighten the clamp and
secure the workpiece. Be sure the clamp is
not in the path of the saw blade.
Note:
When clamping workpieces at angles,
it may be necessary to position the clamp on
the other side of the vise to avoid interfering
with the blade travel.
C-Clamp Vise Removal
1.
remove the lock pins from the vise by turning
the lock nuts clockwise to release the pins
from the holes (
figure 20
).
figure 19.
C-clamp vise.
Vise rod
Clamp Base
2.
remove the clamp lock bolt and the entire
clamp vise assembly. use pliers to carefully
remove the vise pin from the table.
figure 20.
C-clamp vise removal.
lock pin
lock nut
Clamp lock
screw
Vise pin
leadscrew
